How to use Godiag GT107+ DSG Plus Adapter and OpenPort 2.0 to read VAG DQ200/DQ250 gearbox data?
It’s easy to operate. Just make sure the connection between gearbox ECU and devices is proper and set GT107+ analog ignition switch in “Manual” mode.
Godiag GT107+ VW DQ200 wiring diagram:
Godiag GT107+ VW DQ250 wiring diagram:
Connection steps:
Connect OpenPort 2.0 ECU flash tool to computer via the USB cable, and plug it to GT107+ Adapter
Connect GT107+ and DB9 DSG gearbox universal conversion jumper, and connect to VAG DQ200/DQ250 gearbox ECU
Supply 12V power to GT107+
Press GT107+ Automatic/Manual power analog ignition switch and 120 ohm switch
Read DQ200 gearbox ECU:
Run pcmflash 1.2.0 software
Select ECU: [58] VAG: DQ200/MQB Boot (EEPROM)
Identify the ECU model
Read and backup the original eeprom data successfully
Read DQ250 gearbox ECU:
Run pcmflash 1.2.0 software
Select ECU: [58] VAG: DQ250E/F/MQB Boot (EEPROM)
Identify the ECU model
Read and backup the original eeprom data successfully
Done!
VAG DQ200 and DQ250 gearbox data was read by Godiag GT107+ DSG Plus Gearbox Data Adapter and OpenPort 2.0 perfectly.