Godiag GD801 (ODOMaster) Peugeot Citroen Mileage Correction Tips

If you use Godiag GD801 key programmer or Godiag GD801 ODOMaster to do mileage correction on Peugeot or Citroen, after the odometer has been adjusted successfully on the device, the dashboard still shows the same mileage as before. The solution is that you also need to disconnect the instrument to calibrate BSI system. Just follow the tips to operate.

 

Note:

Be sure to back up data of the instrument or BSI before correcting mileage.

 

• Both the instrument and BSI support the operation steps of OBD calibration:

1. First backup the data of the instrument and BSI(remember the file name), so as to recover in case of exception;
2. First, select and calibrate the mileage of the instrument. After the adjustment, do not turn off the engine. Cut off the power of the instrument as soon as possible (remove the fuse or remove the instrument) to avoid data recovery;
3. Select to adjust BSI mileage (or reset BSI mileage to 0). After the adjustment, do not turn off the ignition switch, directly disconnect the negative pole of the battery as soon as possible, and wait for 5 minutes;
4. Connect the negative pole of the battery, and then enter the EEPROM backup function of BSI to read the mileage to see whether the adjustment is successful;
5. Confirm the BSI is successful adjusted, install the instrument or fuse, turn off the ignition switch and lock the door, and wait for 5 minutes;
6. Turn on the ignition switch and check whether the instrument mileage is adjusted successfully.

 

• Only BSI supports the operation steps of OBD calibration:

1. First backup the data of BSI(remember the file name), so as to recover in case of exception;
2. Remove the gauge;
3. Select to adjust BSI mileage (or reset BSI mileage to 0). After the adjustment, do not turn off the ignition switch, directly disconnect the negative pole of the battery as soon as possible, abd wait for 5 minutes;
4. Connect the negative pole of the battery, and then enter the EEPROM backup function of BSI to read the mileage to see whether the adjustment is successful;
5. Use XP or other programmers to back up the instrument data, then adjust and install it back on the vehicle;
6. Turn off the ignition switch and lock the door. After waiting for 5 minutes, turn on the ignition switch to confirm whether the mileage is adjusted successfully.

 

• The BSI type is Delphi operation steps:

1. Press [Read Configuration], be sure the BSI manufacturer is DELPHI
2. Press [Write FL ASH], [Auto update FLASH]
3. Press [Write Configuration]
4. Set dashboard to 0 KM
5. Set BSI mileage
6. Set dashboard mileage

 

• The BSI type is Delphi, Cautions

1. It will take 30~60 mins during testing, keep the vehicle fully charged, and don’t unplug the 0BD connector. Otherwise, it will cause data loss!
2. Steps 1 to 3 you can do only once
3. If the mileage jump back to the mileage before the dashboard is repaired, please perform the following steps:
4. Remove dashboard
5. Set BSI mileage
6. Start the car and drive 2~3 Km
7. Set dashboard mileage
8. Put dashboard into car

 

Alright, the tips above are very important to use Godiag GD801 or Godiag ODOMaster for Peugeot/Citroen mileage correction. Remember to read first before the operation.

 

www.godiagshop.com